
Product Introduction:
This product has steel instructure surface, fitted four-shear beam load cell, with stronger anti- overloading ability. Using steel frame welding instructure,compared with common loadometer, more convenient to calibrate. Low cost,facility maintaince,easily installed。 Widely applied in balance measurement for vehicle, light-van, or Can be used to measure and calibrate axle weight and whole vehicle weight.
Specification:
Rated load:0.5t/1t/2t/3t/5t
Static comprehensive error:0.1%FS
Error on corners:0.1%FS
Output:1.0±0.1mv/v
Zero balance:0~3%FS
Non-linearity:0.1%FS
Defend grade:IP 67
Repeatability:0.05%FS
Ultimate overload:150%FS
Output resistance:87±3Ω
Insulation resistance:≥5000MΩ(100VDC)
Use temp. range:-30~80℃
Compensated temp. range:-10~50℃
Temp. effect on span:0.03%FS/10℃
Temp. effect on zero:0.05%FS/10℃
Recommended voltage:10V
Excitation voltage:9~15V
Netweight:60kg
Max load of 1/4 weigh bridge:0.3t/0.6t/1t/1.5t/2.5t
Full load:0.5t/1t/2t/3t/5t
Dimension of the surface:1100×700mm
Remark:Four-core shielded cable is attached:φ5.5×10m (The cable length can be changed according to customer’s request)
Dimension:
Pressure Transmitter, Pressure Sensor, Pressure Gauge, Pressure Transducer, Melt Pressure Transducer, Melt Pressure Transmitter, Melt Pressure Gauges, Gas Transmitter, Investment Casting, Aluminum Tool Case, Sand Casting, Door Rolle, Shower Room, Pitcher water filter, Die Casting, Hydraulic Pump, Electric towel radiator, Roller chain, Vertical blinds.
%u4E2D%u6587%u7248